IN THIS DESIGN DEFECT PRODUCTS LIABILITY CASE, THE LOSS OF THE SPECIFIC PRODUCT WHICH CAUSED THE INJURY DID NOT PREVENT DEFENDANT-MANUFACTURER FROM PRESENTING A DEFENSE; THE COMPLAINT SHOULD NOT HAVE BEEN DISMISSED ON SPOLIATION GROUNDS (FIRST DEPT).
The First Department, reversing (modifying) Supreme Court, determined defendant-manufacturer (Doka) of an allegedly defective ratchet was not entitled to dismissal of the complaint on the ground that plaintiff could not produce the ratchet (spoliation). The ratchet was used to move heavy concrete forms into place along a track. Allegedly the ratchets broke when extra pressure was placed on them when the forms became “bound” on the track. Plaintiff alleged he was injured when he used his foot to increase the pressure on the ratchet when the form became bound. Because this was a design-defect case, and because the ratchets allegedly had broken before under similar circumstance, the defendant-manufacturer could present a defense and, therefore, the loss of the ratchet did not warrant dismissal of the complaint:
In cases like this, where the claim is based on a design defect (as opposed to a manufacturing defect), the absence of the product is not necessarily fatal to the defendant. As this Court has observed, a product’s design “possibly might be evaluated and the defect proved circumstantially” … . Circumstantial evidence could, one would imagine, be the testimony of someone involved in the design process, and plans or photographs of the product before it entered the stream of commerce. It could also, assuming that the missing product was one of multiple units manufactured using the same design, be another one of those units. * * *
Doka does not, in any meaningful way, argue why its inability to inspect the exact ratchet that plaintiff was using would prevent it from defending against the products liability claim. Rossi v Doka USA, Ltd., 2020 NY Slip Op 02098, First Dept 3-26-20
